Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - peug

Pages: [1]
1
SuperBoundary • General Discussion / Re: TotalBoundaryPro
« on: October 24, 2024, 09:58:23 PM »
I have since tried on another type of object and it worked. However, the right side has an indentation that doesn't occur on the left side, when two vertical objects have the same x coordinate and there is a gap.

2
SuperBoundary • General Discussion / TotalBoundaryPro
« on: October 24, 2024, 06:57:01 PM »
Hello,

There is no forum for total boundary and my message through the contact form has not been responded to, so I will post here. Total boundary is not enclosing these objects. Is it possible to do so with TB or any other product you offer? Specifically I would like a single boundary for all selected objects, not individual boundaries.

Pages: [1]