Debalance Research Group • Forum

SuperBoundary • Superior replacement for the BOUNDARY (BPOLY) command => SuperBoundary • General Discussion => Topic started by: peug on October 24, 2024, 06:57:01 PM

Title: TotalBoundaryPro
Post by: peug on October 24, 2024, 06:57:01 PM

Hello,

There is no forum for total boundary and my message through the contact form has not been responded to, so I will post here. Total boundary is not enclosing these objects. Is it possible to do so with TB or any other product you offer? Specifically I would like a single boundary for all selected objects, not individual boundaries.

Title: Re: TotalBoundaryPro
Post by: peug on October 24, 2024, 09:58:23 PM

I have since tried on another type of object and it worked. However, the right side has an indentation that doesn't occur on the left side, when two vertical objects have the same x coordinate and there is a gap.

Title: Re: TotalBoundaryPro
Post by: Debalance on November 08, 2024, 06:54:09 PM

Hello! Thank you for your question. Can you provide me with your drawing so I can see everything in more detail?